Hydraulic table press model "R-40"
Maximum compression force: 400 KN (40,000 kg / cm3)
The maximum diameter of the tablets: 100 mm
Minimum diameter of tablets: 10 mm
Height of finished tablets: up to 70 mm
Maximum matrix depth: 150 mm
Tablet press capacity: 300 tablets / hour
Pusher stroke: 155 mm
Lever Length: 490 mm
Overall dimensions: 380mm x 265mm x 390mm
Tablet press weight: 45 kg
Shipping Weight: 55 kg

The desktop hydraulic press is applicable as a laboratory press in the chemical, metallurgical industry. Includes replacement oil seals and supplies. We produce any molds and dies. The main part of the press is the base plate, the main plate combines load-bearing racks and the upper base plate. A hydraulic cylinder, a dynamometer and a lever system are mounted on the main plate. A press tool and a die are mounted on the working surface of the hydraulic cylinder. The press cylinder is controlled by a screw stop. The whole process of the hydraulic press can be divided into:
(a). Matrix filling,
(b). Powder compression
(c). Popping the finished pill

These three actions are performed in order to comply with the parameters of the obtained tablets. The laboratory bench-top hydraulic press is a compact, bench-top device. After you install the press on the table, you can use it. The design is convenient to assemble or dismantle. Indications 1 MPa = 6.5 KN 1 KN = 0.154 MPa
Installation: Assemble the press, install the matrix on the table surface of the hydraulic cylinder, manually fill the matrix with powder, after measuring the required weight with a measuring cup. Install the punch in the matrix, press the punch on top with a screw stop. Establish the lever and begin to create pressure in the hydraulic cylinder with swinging movements. On the dynamometer you will see the testimony of the force you create. Then bleed fluid from the hydraulic cylinder, raise the stop screw slightly up. Place supports under the die, then press the lever again to squeeze the finished tablet out of the die.

There is no analogue to this model. Compact table press with pressure up to 40 tons !!! Immediately took this to production.

Igor, Volgograd

If everything is thought out and prepared, then tablets of very large sizes can be successfully pressed on this press. If desired, you can unscrew the standard long four racks and fasten the elongated. This will allow you to set the matrix even greater height.

Michael, Novosibirsk city

Thanks for the help! When choosing a technique for compressing tablets. A hydraulic press has proven to be a suitable option for us.

Tikhomirov Andrey, Tula

I called by the end of the working day, I thought no one would answer, but to my surprise they answered, they advised me well about the laboratory hydraulic press, and I think I will opt for R-40 and order it in the same company.

Spiridonov Miron Ivanovich, Penza

We were faced with the problem of finding equipment for a laboratory, namely a laboratory hydraulic press. Found on the Internet Minipress. Asked for help. We helped to choose, delivered on time.

Mironchik Alexander, Petrozavodsk

We have been using a laboratory hydraulic press for about a year. The best model of all that we used.

Nina Bratova, Director, Nalchik